Marmitek SWM1P Bedienungsanleitung PDF herunterladen (Seite 20)

Remote operation

The table below shows the various operating commands for operating the

sunblind module.

Command Reaction

<Motor address> On The sunblind moves up completely.

< Motor address > Off The sunblind moves down completely.

< Motor address > DIM+ The sunblind moves one step up. With multiple

consecutive DIM+ commands the sunblind will keep

moving until the commands stop or the sunblind

reaches the end position.

< Motor address > DIM- The sunblind moves one step down. With multiple

consecutive DIM- commands the sunblind will keep

moving until the commands stop or the sunblind

reaches the end position.

< Motor address> Extended The sunblind moves to the position indicated in the

extended command.

<Preset address> On The sunblind moves to its saved Preset position.

<Preset address> Off None.

<Preset address> Extended The value in the extended command is saved in the

sunblind module as Preset position. The sunblind

does not move

Below you can find some practical programming examples.

Multiple roll-down shutters with one Preset mode

Program the Preset address of all sunblinds in for instance the living room to

the same address. With the Preset key of any sunblind modules in this room

or by means of sending the Preset address ON via a Marmitek interface all

sunblinds can be set to the Preset mode simultaneously.

Multiple Presets for one sunblind

If you need a different Preset position in the morning than in the afternoon,

you can program this position in advance at the Preset address with the

extended command using the scenario’s that can be programmed in the

Marmitek CM15Pro Computer Interface. When operating the Preset key the

sunblind will move to the position programmed at that moment.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Keine Kommentare

Marmitek SWM1P Bedienungsanleitung Seite 20