11AWM2P™
ENGLISH
Figure 5
Activate or exit the setup mode.
Programming the X-10 address and the various options
The chart below shows the various possibilities to program the
MicroModule AWM2P
defaults Programmable Command Light blinks
Address A1 Address A2 to P16 2x Address 2x
Doesn’t respond to
“All Lights On”
Responds to “All
Lights On”
2x “All lights on” 2x
Doesn’t respond to
“All Units Off”
Responds to “All
Units Off”
2x “All Units Off” 4x
For programming the Marmitek X-10 address and options you will be
able to use any Marmitek X-10 controller or remote control. For the
following explanation we used a Marmitek 8-in-1 remote control to
Kommentare zu diesen Handbüchern