Marmitek MultiMedia Remote Bedienungsanleitung PDF herunterladen (Seite 4)

4 © MARMITEK

1. Modules

These components will receive Marmitek X-10 signals and will switch

or dim the attached lamp or appliance.

2. Controllers

These components will transmit Marmitek X-10 signals and thus will

control the Modules.

3. Transmitters

Wireless components like remotes. The signals of these components

will be received by a controller with transceiver functionality (IRRF

7243, TM13, CM15Pro or console of a Marmitek SecuritySystem).

The Transceiver will translate the signals into Marmitek X-10 signals

on the power line.

ADRESSES

Up to a maximum of 256 different addresses can be preset. These are

subdivided into a so-called HouseCode (A to P incl.) and a UnitCode

(1 to 16 incl.). The HouseCode can also be set on the controllers, so

that the controllers and modules become part of the same system.

The address can be set either using code dials or by pressing buttons,

depending on the type of module.

The Marmitek X-10 System uses standard commands, which control

all units with the same HouseCode at the same time (e.g. all lights

on, all off, etc.).

SIGNAL RANGE

Range of Marmitek X-10 signals over the Power Line and how

to increase the range.

The Marmitek X-10 System is based on power line communication. The

range of the Marmitek X-10 signals very much depends on the local

circumstances. On average the range is a cable length of 80 meters.

If you have difﬁculties with the range of your Marmitek X-10

signals, please pay attention to the following facts:

1. When several phases are used in the house, it can be necessary

to couple these phases for Marmitek X-10 signals. You can

1 2 3 4 5 6 7 8 9 ... 13 14

Keine Kommentare

Marmitek MultiMedia Remote Bedienungsanleitung Seite 4