Marmitek MultiMedia Remote Bedienungsanleitung PDF herunterladen (Seite 15)

FREQUENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off

spontaneously?

It is possible that a Haibrain X-10 System is installed at one of

your neighbours using the same House Code. To solve this

problem try to change the House Code of your system, or have

FD10 Phase Coupler/Filter installed at your incoming mains.

My modules will not respond to my controller.

Make sure that the House Code on all Modules and Controllers

are set to the same House Code (A .. P).

My modules will not react to my remote / sensor.

When

you use a remote or sensor, you should have at least one TM13

Transceiver or Haibrain Security Console installed in your house.

These components will translate the radio signals to the Haibrain

X-10 signal on the power line. Only one Transceiver should be

installed for all remotes and sensors set to the same House Code.

Am I able to increase the range of my remotes by using

more Transceivers?

es, you can use more than one TM13 Transceiver in your home

when the range of your remotes is not sufficient. The TM13 is

using so called collision detection to prevent signals to be

disturbed when more than one TM13 is transmitting. TM13’s will

wait for a quite power line before transmitting their data. To

prevent your Haibrain X-10 System to become slow or to prevent

dimming from becoming less smooth, make sure that the TM13

units are placed as far away from each other as possible.

The module suddenly starts to blink for a short time.

Electronic dimmers, such as the LWM1P, make use of cutting in or

cutting off the sine in order to transform voltage. In an unstable

mains system, or as a consequence of short low frequency pulses,

the shape of the sine can be disrupted, resulting in light

variations. This phenomenon does not harm the modules.

LWM1P

ENGLISH

1 2 ... 10 11 12 13 14 15 16 17 18

Keine Kommentare

Marmitek MultiMedia Remote Bedienungsanleitung Seite 15